RTRYVA™ Indoor


Pre-fibred  FTTH  Telecoms  Indoor  

The new 6mm RTRYVA™ Indoor is our smallest retractable pre-installed fibre solution - 8 fibre drops in one discreet cable. 8 x faster and easier installation will save you time and money, no blowing, no splicing, no connectorisation within the cables route.

It’s our most flexible and discreet multi-drop solution that is quick and easy, using a minimal amount of tools, training, and equipment needed for a fast horizontal or vertical (in risers) installation within buildings (e.g. Multi-Dwelling Units).

This Low Fire Hazard (LFH) Cable is independently CPR tested and approved, rated as B2ca - an indoor cable safe for ALL buildings regulations.

Key Benefits

  1. 1.

    Pre-fibred indoor cable solution with 8 fibre drops in one small 6mm cable.

  2. 2.

    No additional splicing or blowing required at each customer break-out point.

  3. 3.

    Class B2ca CPR rated - an application safe for ALL building regulations.

Key Features

  • 1 cable route rather than 8 - access and re-direct the 8 fibres with window cuts from this one RTRYVA™ cable.
  • Improved indoor homes passed and homes connected commercials - saving time and cost.
  • Made with G.657.A2 fibres for a tighter minimum bend radius - ideal for using in tight indoor spaces.
  • Fibres can be pulled back by as much as 30 metres (route dependent).

Installation Steps

  1. 1.

    Mark out 300mm lengths between each required FireClip.

  1. 2.

    Drill the required holes for all FireClips and push clips over the RTRYVA cable to fix into place.

  1. 3.

    Using the Break-Out Bend Manager, mark out and drill the passage for the fibre drop to the other side of the wall.

  1. 4.

    Place and fix to the wall with a screw and if the cable is continuing its route for more fibre drops, remove the end cap to allow the cable to pass through.

  1. 5.

    Place the cable within the Break-Out Bend Manager and mark start and end points for a window cut.

  1. 6.

    Remove from the Break-Out Bend Manager and use a window cutting tool to access the fibres.

  1. 7.

    Place the cable back into the Break-Out Bend Manager, now the fibre can be selected and pulled back.

  1. 8.

    Once the fibre has been retracted, start pushing it through the drop tube to the other side of the wall into another Break-Out Bend Manager.

  1. 9.

    When complete, push on the cover for the Break-Out Bend Manager until it clicks into place.

Select Documents

SELECT DOCUMENTS
Brochure - RTRYVA Indoor 6mm
Datasheet - CP4681

RTRYVA

Product image

Emtelle’s RTRYVA is a pull back fibre optic cable giving a very flexible FTTX solution.


DETAILS

GOT ANY QUESTIONS? SPEAK TO OUR SOLUTIONS EXPERT

CONTACT US

JP TERBLANCHE
PRODUCT SPECIALIST


Subscribe to our Newsletter